Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Voice over IP using E1 Lines

Hello,

I am planning to shift normal FXS cards to E1 cards so that i could use E1 lines and their 30 channels using one cable other then using a whole lot of FXS cards each giving just two connection points. I am using 2801 and 3845 routers. Kindly suggest me some Network modules and E1 Cards that support voice and also some example configuration for it. Thanks in advance.

Regards,

Jay Kishan

2 REPLIES
Hall of Fame Super Gold

Re: Voice over IP using E1 Lines

Hi,

what router do you have? Generally today the VWIC-xMFT-E1 and the VWIC2-xMFT-T1/E1 are used.

New Member

Re: Voice over IP using E1 Lines

if u want to use all the channels on E1 , below is a sample config.

controller E1 2/0

framing NO-CRC4

pri-group timeslots 1-31

note: CRC-4 OR NO-CRC4 , same config must be on router and pbx.

interface Serial1/0:15

description -- Q.sig

no ip address

no logging event link-status

isdn switch-type primary-qsig

isdn protocol-emulate network

isdn incoming-voice voice

isdn sending-complete

no cdp enable

voice-port 1/0:15

input gain 1

output attenuation -6

echo-cancel coverage 32

cptone IN

description --- To E1 1/0

busyout monitor Serial0/0.1

hope it helps u, other than this u hav to configure the pots dial-peer and some global config for voice.

128
Views
0
Helpful
2
Replies