Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Voice setup Hardware Requirement

Hi

Im currently having cisco 2621XM router with a integrated 2 fast ethernet port plus 2WIC.

we are planning to configure voip.but not sure what are the additional parts that i should purchase.can anyone tell me what are the additional module which i need to buy.

as far as i have search through cisco website, i managed to find out that i need a Network module which support voice such as NM2V plus 2E&M vic card.

so my question is how about the DSP module ? so i need to purchase any DSP module?.

please advice me on what are the necessary modules which i need to run voip in my 2621 router.

Thanks

Regards

S.Jegathisan

Network Spport Engineer

1 REPLY
Community Member

Re: Voice setup Hardware Requirement

Hi

well i have found the answer myself. anyway for those who might face same situation as me...

To setup voice in 2600 routers the hardware requirement are as below

1.Network module NM 1V or NM 2V

2.E&M voice card ( VIC 2 E/M)

and for the PVDM DSP module. for cisco 2600 the NM 1V or NM2V has build in dsp module.

for comfiguration part and for more infor pls visit

1.http://www.cisco.com/en/US/products/hw/routers/ps274/products_data_sheet09186a0080091ba1.html

2.http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a0080094ab9.shtml

Regards

Jegathisan

122
Views
0
Helpful
1
Replies
CreatePlease to create content