cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
667
Views
0
Helpful
2
Replies

Voip auto QOS 3560 - queuing working?

dsalmon01
Level 1
Level 1

Hello All:

I have recently deployed Auto QOS for VOIP on a 3560 using Mitel phones. This is a test case for my enviroment.

Auto QOS has done its magic with multiple entries and all looks correct, but when I check a given interface with 'show int fa0/x' the queuing strategy comes up as FIFO. Should it not be SRR for the 3560? Not sure the queuing strategy is being applied.

Any help appreciated.

Thanks,

Dan Salmon

2 Replies 2

Collin Clark
VIP Alumni
VIP Alumni

Dan-

Try this command instead,

show mls qos interface queue

You should see something similar to this,

FastEthernet0/9

Egress Priority Queue : enabled

Shaped queue weights (absolute) : 25 0 0 0

Shared queue weights : 10 10 60 20

The port bandwidth limit : 100 (Operational Bandwidth:100.0)

The port is mapped to qset : 1

Thanks for the info.

I had a chance to try the command today.

Here is the output:

sw3-acs# show mls qos int fa0/14 queueing

FastEthernet0/14

Egress Priority Queue : enabled

Shaped queue weights (absolute) : 10 0 0 0

Shared queue weights : 10 10 60 20

The port bandwidth limit : 100 (Operational Bandwidth:100.0)

The port is mapped to qset : 1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: