VOIP calls not being forwarded from GW to GK and visa versa
I have a VOIP network setup in place using 2691 routers. i have a siemens PBX connected to the 2691 routers using an E1 controller (running QSIG), my WAN interface between the two sides is an ATM interface. when i do a csim start from one router to the extension on the other side the call goes through and the phone rings. However, when i actually dial from one extension to the other, the call is not being forwarded. and what happens is that i hear the dial tone again on the phone im dialing from.
I have taken some debugs but still could pin point the problem, even though in the ccapi inout debug i found that when it tries to look for a node, it doesnt find it.
I have attached the configuration for both sides. Along with the debug from one of the sites.
There are a couple of GW's associated with the GK.
The ones im concerned about are Mussalla_GW & GK-HO.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...