Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VoIP Trunking / Communication

Hello -

I have a location that is currently running two parallel networks. One for data and one for voice. The data netowrk is running a 3750 stack for L3 and 2960s for data. The second is running 3560 PoE to a 3825 router for CME. I would like to trunk the 3560 to the 3750 for routing and then the 3750 to the 3825 for voice routing. I have gone through the qos trunk steps to make this happen, created the DHCP Pool with Option 150 back to the 3825, and trunked the port between the 3750 to the 3825, but I cannot get the phones to register. I duplicated the existing configs and still no luck. Is there a standard config that I can use to make this happen? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: VoIP Trunking / Communication

if u trunked the link between the switch and the CME so what IP u have given in the option 150?

if u have the CME only for ur voice network make the link between the switch and the CME as routed interface and make a route on ur switch and also a route on ur router point to the swtich interface

if u have bothe data and voice flowing through the the CMe them make the link trunk and make subinterfaces on the CME link to the switch

make sure to make the ip source address in the CME under telephoney serves the same as the ip u put it for option 150

good luck

please, if helpful rate

1 REPLY

Re: VoIP Trunking / Communication

if u trunked the link between the switch and the CME so what IP u have given in the option 150?

if u have the CME only for ur voice network make the link between the switch and the CME as routed interface and make a route on ur switch and also a route on ur router point to the swtich interface

if u have bothe data and voice flowing through the the CMe them make the link trunk and make subinterfaces on the CME link to the switch

make sure to make the ip source address in the CME under telephoney serves the same as the ip u put it for option 150

good luck

please, if helpful rate

133
Views
0
Helpful
1
Replies