Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Vonage VoIP and PIX 501

I have a SOHO currently using cable modem connected to the outside interface of a PIX 501. The inside interface of the PIX connects to a hub with 8 ports.I have 2 PC's and a LinkSys AP plugged into the hub. I have been looking at using Vonage VoIP. My questions are:

1) Is it possible?

2) Do I need to use a special fixup protocol or config?

3) Has anyone used Vonage VoIP and how is it working?

Thanks,

Paul Lane

3 REPLIES
Community Member

Re: Vonage VoIP and PIX 501

Paul,

I have been using Vonage succesfully with a very similar configuration. You don't neet any fixups or special configurations to make this work.

My only suggestion is to connect your ATA to a switch port behind the PIX, as opposed to the hub.

Have fun!

Fernando Macias

Community Member

Re: Vonage VoIP and PIX 501

Thanks you!

Community Member

Re: Vonage VoIP and PIX 501

Hi Luis,

I plugged the Motorola ATA into one of the 4 available ports in back of the PIX 501, and I don't receive any dial tone at all. Has this ever happend to you? How did you set up your ATA?

Thanks

Paul Lane

160
Views
0
Helpful
3
Replies
CreatePlease to create content