Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

VWIC-MFT1 on ICS7750 using FXO from DMS-10

I'm having trouble getting a digital T1 configured as a ds0-group on an MRP-8FXS card. I have a VWIC-MFT1 in port 1/0 and if I configure it for a PRI, I can bring the trunks into service and answer calls. If I set it for a digital T1 CAS circuit with FXO or FXS, the trunks appear to be in service, but any calls placed from the PSTN to the dial number overflow into a recording. No digits show on my debugs, so it almost seems as though the trunks are busied out. From the DMS-10, the trunks appear idle as well. Help!

Thanks,

Ken

  • Voice over IP
1 REPLY
Silver

Re: VWIC-MFT1 on ICS7750 using FXO from DMS-10

Have you installed the VWIC-MFT1 in the NM-HDV unit ? If it is installed in a WIC slot it may not work. I dont know about the MRP-8FXS card. May be it works.

340
Views
0
Helpful
1
Replies