VWIC-MFT1 on ICS7750 using FXO from DMS-10

[johnson.k]

I'm having trouble getting a digital T1 configured as a ds0-group on an MRP-8FXS card. I have a VWIC-MFT1 in port 1/0 and if I configure it for a PRI, I can bring the trunks into service and answer calls. If I set it for a digital T1 CAS circuit with FXO or FXS, the trunks appear to be in service, but any calls placed from the PSTN to the dial number overflow into a recording. No digits show on my debugs, so it almost seems as though the trunks are busied out. From the DMS-10, the trunks appear idle as well. Help!

Thanks,

Ken

[irisrios]

Have you installed the VWIC-MFT1 in the NM-HDV unit ? If it is installed in a WIC slot it may not work. I dont know about the MRP-8FXS card. May be it works.