Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

VWIC2

Hi I have a 2811 and I'm using a VWIC2-2MFT-T1/E1 card, but when I try to configure the E1 controller this doesnt appear in the configuration. I know that it is necessary the IP Plus or IP voice feature set for IOS. But is it possible to have another issue so this doesnt work?

And another doubt I have, is it possible that this card works with limited functionality without this feature set?

Thanks

2 REPLIES

Re: VWIC2

Hi

Have you tried command card type e1 1 (where 1 -- slot 1 (port1) on the router) ??

regds

New Member

Re: VWIC2

I am pretty shure that this is the problem

car type e1 x

will solve it but if not execute

show diag

and observe the output to see if the card is realy there (if it's not maybe you have a hardware problem)

128
Views
0
Helpful
2
Replies
CreatePlease login to create content