NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 4", DESCR: "PVDMII DSP S IMM with four DSPs" PID: PVDM2-64 , VID: V01 , SN: FOC14172E9L
NAME: "PVDMII DSP SIMM with four DSPs on Slot 0 SubSlot 5", DESCR: "PVDMII DSP S IMM with four DSPs" PID: PVDM2-64 , VID: V01 , SN: FOC14113RGJ ======================================
SWFC-DCBB-VG02#sh running-config Building configuration...
Current configuration : 4836 bytes ! ! No configuration change since last restart ! version 12.4 service timestamps debug datetime msec service timestamps log datetime msec service password-encryption ! hostname SWFC-DCBB-VG02 ! boot-start-marker boot-end-marker ! card type e1 0 0 card type e1 0 1 card type e1 0 2 card type e1 0 3 enable password 7
enable password 7 02050D4808095D ! no aaa new-model
Please advise if Adrian's tip has fixed this or not, but you may also want to run the DSP calculator to ensure you have enough DSP resources left over. By the looks of things, you have 8 E1 circuits enabled, which I'm estimating could be using up all your DSP resources.
You might also want to remove any unused codecs from your xcoding/conference profiles, as they will also take up extra resources, even if you don't end up using them.
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...