Hello,
I searched for this information without finding an answer : Is it possible to change the ring tone of the Cisco 501G? If so, in what way ?Thanks for your help
I'm using the SPA 303 handset. After looking around the web for solutions to use an unused line for BLF for my assistant's extension, it's not exactly working after following instructions. Their name/ext shows on the unused line but this appears to b...
I have a customer with a SPA232D being used on a residential analogue phone with a built in answering machine. Outgoing VOIP is working fine and incoming phone calls are working fine when the answering machine option is turned OFF. BUT while answer ...
Dear all,
I did all the configuration via vlan90 and loopback interface to reach the service module, but no way.
I also enter to the CUE-offline-restore factory default then configure the ip address and the GW,, is this step nesscarry or it is enough...
I have just been asked to configure a specific SPA504G phone (extension 101) so that some sort of BLF (actually any LED on the phone) flashes when the core Asterisk call flow toggle (say 282) is active. years ago I barely escaped programming an SP...
Hi. I am new here, so please bear with me. - My call display was not working. So my telephone provider told me to disconnect the phone cable from the adapter foe about 45 seconds. I did that, and since then the phone has been dead. I tried disconnect...
The documentation helped me dope out how to program a PSK to dial an extension and then how to place that PSK on the soft key (Dope being the proper adjective to describe me at this point)
This comes in very handy for, as an example parking .. wher...
HI All
I am programming up a number of SPA508's each with 8 SIP lines. All connected to buttons 1 - 8 respectively.
How can I set the default line (button) to be say button 4 (bottom right) when the handset is picked up rather than top right butto...
I need someone's help...
I am new to this field, learning one by one.
I have SPA525G, 5-Line IP Phone.
I succeeded to register one(1) number, but though I did the second, by logging in to the phone through web browser and my phone server shows both n...
Hi,I'm having some issues with the SCA line id mapping on a 525 phone. Firmware version is 7.4.3. I want the SCA to have Vertical first, but the second call is still appearing on the first line key. The phone is in SIP mode.I've tried the upgrade fro...
I want to upload an Auto Attendant prompt that was done for the company to my UC320 but i see no option to do that.Is there a way to do that without doing it from a ip phone connected to the system.Thanks.
I'm assuming the answer is no but it is possible to force a resync even if the "Provision Enable" option is set to No?
The phones in question have Auth-Resync-Reboot set to Yes. So the notify message would be authenticated. I verified the reverse ...
I have purchased a SPA112 ATA, connected it, obtained through the IVR the address, and when I try to connect to the configuration page using the default password admin, I notice about ten more dots added automatically to the password field, and the p...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: