Voice Systems and Accessories - Small Business

Hi,Working with a 504g, and trying to create a softkey to allow some *codes to be used during a call.The phone is attached to an asterisk 1.6.2 server. (Not SPCP)Currently the manual states you have to enable the programmable Softkey feature (see att...

Hi Everyone,Can anyone show me or give me a link on where i can find a document with all commands prompts for the UC520 that I can print or download. Thank you

I have a IP Phone on my desk which I use as a primary. If I sit at another employees desk temporarily, how do I log into her phone to receive calls made to my extension?Do I need to turn this feature on in the UC-540 first?Phones are 7975G and 7925 c...

Caller gets a fax tone but always errors out. I was originally trying x801 but had the same problem. Changed to x291 - no differenceI have followed the 7.37 onramp document that Marcos had referenced in posting pretty much exactly. I am using CCA 2.2...

Hi everyone,I've downloaded and installed the Cisco Call Connector for dynamics CRM, I've installed on a test machine and everything was installed correctly.Although now on the live server, the server installation says you need to manually enable the...

Hi!,I´m configuring provisioning files for my new SPA-525G. I´ve configured  "Protect_IVR_FactoryReset" and I would like to Password Protect some other options. I don´t want to use Admin Password, because it protects all options in the phone menu. Do...

I am using SPA9000 with SPA400 and SPA9** . 2 PSTN lines connected on Line 1 and 2, after configuring SPA9000 and SPA400, I have routed line1 to Ext:111 and line2 to Ext:107. when i try to dial these 2 PSTN lines from outside, it rings on Line2, Ext:...

Hi,fairly new to the SPA9000 and probably asking something obvious but if you had two SPA9000s on a reasonably fast WAN can they communicate / route calls directly? Site-to-site routing in place for IP traffic. Also, is there an easy way to do call a...

I have a UC-540 with an active Cisco XP support agreement.Where can I go (URL please) to download a software based phone (softphone)?Do I need to purchase a license for IP COMMUNICATOR & LIC FOR CALLMANAGER (CISCO Part# L-SW-IPCOMM-E1-CH1) ?Will the ...

would like to know if there’s a way to restrict Linksys ATAs(mainly SPA2102/3102-R) and IP Phones(SPA 9x2/500series) to only accept SIP invites from the IP they register to? Can’t seem to find a parameter that would suggest it can, so it’s either it ...

I have a simple setup.  2 x FXO lines.  2 x 502 phones.  I setup a call blast group (pilot #501) to ring both phones for 10 seconds then forward to extension 201's voicemail.  Both phones ring no problem for 10 seconds but then the call disappears.  ...

We are setting up a project to consolidate 7 locations to a colocation site.We need a firewall at each of the 7 remote sites for around 10-20 at each site.Then we need one at the colocation for approx. 70 users...we were thinking of the ASA 5510.In t...