Voice Systems and Accessories - Small Business

HI Community,I am having troubles registering a SIP device to our system, we are conducting a LAB test on a SIP/VoIP payphone, i understand that Generic SIP devices are not supported by Cisco, however there might some people in here that have managed...

We have been experiencing erratic call behavior on our ip phones since sometime now. For every 1 out of 3 incoming calls, the call from the outside goes directly to the user's voicemail or gets d/c even though the phone was not busy. We get an email ...

Hi,Simple little question hopefully, when someone leaves a voicemail the MWI doesnt seem to light up, however it is enabled and when I manually dial the extension I can get the indicator to switch on and off. I have left the settings as default ext A...

Hi,Just want to clarify if its possible to do a transfer from 962 to one of the speed dials on the 932 via any lines on 962, as it whats happening on my end is even though Im using say Line 6 on a call, and want to transfer this call via one of the s...

Hello... I've configured an extension for prompt management which works well up to the authentication part. It keeps rejecting the user PIN. I've added more than one user as member to the group all with the same problem.Any ideas?Thanks.Vincent

Numbers appearing on phones as monitor, when call is transfered cannot light busy lamp when pickup on 7962 phones and phones with 7915 sidecars. Normal operation fine

Has anyone else ever had an issue with "complex" WPA passphrases and the WIP 310?  I'm trying to join a network where the password is (example, not the real password) !ThenATwentyCharacterString!The 310 doesn't seem to like the "!" in the password - ...

Does the UC 520 have the ability (in a find me follow me environment) to round robin calls through 6 numbers?  If call is answered at #3 then to stop the round robining, but if call is unanswered through all 6 numbers, can it pull the call back into ...

We have several customers that have external music on hold devices connected to the UC520 unit. They are reporting the following problems with the Music on Hold on the UC520:Music on Hold is too loudCallers can hear noise when music on hold is played...

I had a VPN tunnel working with a UC500 and SR520.  I installed the SR520 at a customer site.  I pulled another SR520 out of the box and restored the config from the previous SR520.  The VPN tunnel will not work.  I have attached the show run from bo...

Hello everybody,customer have this configurationSPA9000SPA942 - 3xSPA400with2x SIP account1x PSTN line via SPA400if customer calling opposite side have very silent audioHow i can change sensitivity of microphone in SPA942 ?Regards,Tomas

I don't know if this is the place for "Linksys One" issues but I'll give it a shot anyway. I have a bit of an issue and with a multi-site installation of the SVR’s and was wondering if you could lend your technical expertise to take a look at routing...

Hello,is it possible to add a VIC2-2FXO on a UC520W-8U-2BRI and use both BRI and FXO ports ?Thanks for your answerStéphane

Hello,Since there's a limit of 15 on the number of entries in voice-translation rule how can I configure more than 15 DIDs?I already tried adding a voice-translation rule 2 with a second translation-profile and another dial-peer voice to match but th...