I am trying to set up a 7960 series phone for use with a cytracom hosted IP service
trouble is, I can't even get into the phones SETTINGS
I was able to default the phone by pressing and holding the # key on boot, then entering the 123456789*0# code;
however, I cannot get the phone to respond when pressing the SETTINGS button while the phone is booting.
The phone goes through its normal boot up procedure, endig in the error of not finding the TFTP server (TFTP file not found), but I can't get the settings button to respond so I can adjust where it's looking for the new TFTP server...
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...