Need assistance troubleshooting guest wireless access from being blocked by ACL.
Customer is using UC520 and AP541N. We want to block traffic from VLAN 10 (172.16.10.0/24) to VLAN 1 (192.168.10.0/24). We have tried inbound and outbound ACLs, but I don't see any traffice matches. Below is the configuration.
UC500 Advanced IP Services IOS version 15.1(4)M5
ACL applied to VLAN 1 inbound:
Extended IP access list 102
10 permit udp any host 192.168.10.1 eq non500-isakmp
20 permit udp any host 192.168.10.1 eq isakmp
30 permit esp any host 192.168.10.1
40 permit ahp any host 192.168.10.1
50 deny ip 172.16.10.0 0.0.0.255 any
60 deny ip 10.1.10.0 0.0.0.3 any
70 deny ip 10.1.1.0 0.0.0.255 any
80 deny ip host 255.255.255.255 any
90 deny ip 127.0.0.0 0.255.255.255 any
100 permit ip any any (3375999 matches)
ACL applied to VLAN 10 outbound
Extended IP access list 106
10 deny ip 172.16.10.0 0.0.0.255 192.168.10.0 0.0.0.255
20 permit ip any any (38 matches)
Software version 9-2.0(2)
VAP 0 maps to VLAN 1
VAP 1 maps to VLAN 10
The link between the UC520 and AP541N is setup as a trunk.
Please let me know if you require more information to troubleshoot. Thanks in advance!
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...