02-02-2012 03:29 PM - edited 03-21-2019 05:17 AM
I have recently set up a new SIP provider on a UC560 that requires all numbers be 11-digit numbers starting with a 1. Is there any good way to have an outgoing dial-peer to translate all numbers dialed without 1 to add a 1 and the same time if someone does add a 1 a to the number they are dialing that system will treat it normally?
02-02-2012 06:51 PM
Via CLI you can in the dial-peer to prefix a 1
Sent from Cisco Technical Support iPhone App
02-02-2012 06:55 PM
Do you mind providing an example? Even sudo-code would be appreciated.
02-02-2012 07:02 PM
Basically gain access via CLI
Located the dial-peer, commands as follows when in enable mode
Conf t
Dial-peer voice XX pots
Prefix 1
End
"XX" is the dial peer number you want to edit.
Let me know if you need additional commands
-Mario
Sent from Cisco Technical Support iPhone App
02-02-2012 07:03 PM
That's perfect. Thank you very much.
Sent from my iPhone
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: