I have a translation rule that appears to be at its max with 15 rules. I need to add more to this and wonder how to do it. The rule is made to point DID's to individuals extensions. We are trying to assign a second set of DID's to each user and once I got to 15 rules inside the translation-rule it does not allow me to add. Below are the pieces that make up the rule.
For what I saw in your config, your provider is delivering the last four digits of the full number. You currently have a translation rule that changes that into the internal extension. But since you ran our of rules, you have to either create more, which requires dial peer manipulation, or tell the system that those four digits are also a valid pattern for the DN (using the secondary command).
A great way to verify what you are getting is by enabling the following debug
debug isdn q931
Look for the field "called number" in the inbound Q931 Setup. When you are done, turn off the debugs:
Marcos - you gave me the right answer again - number 101 secondary 2008 no-reg both was the trick. I just didn't see it the first time I looked at it. When I actually plugged it in the CLI it made perfect sense. Now I can go into the 12 existing EPHON-DN's related to users DID's and add this command.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...