Auto Dial - Hot Line on UC540 not working correctly
I have setup Auto dial to ring blast group 512 from extension 102 (CP-7931).
When I pickup 102 it rings the blast group, but I can only hear the ringing tone for the first ring. It then goes silent, but still rings on the blast group. I can talk to the person if the phone is answered.
Implemented using CLI:
#ephone-dn 1 ?ephone-dn of 102 phone
#trunk 511 ?Blast Group number
#ephone 1 ?ephone of 102 phone
I have also attached the config. Any help would be appreciated.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...