I have conected SPA112 ATA to UC 560. I can make calls from but not to SPA112 ports. in ccsip debug i see that UC is trying to reach spa trough outside sip-server. I added spa through cli becouse when i add it trough cca it disables sip trunk witch is my only trunk for outside calls.
Any idea how to make dial-peer and force UC to use it when calling spa extensions. all calls to spa extensions are made from same number whith is conneected to UC fxs port as Common area phone.
spa extensions seem to be registered according to spa gui line status and i can make outging calls. I have same configuration on another site only diference is that there i am using BRI interfaces for PSTN and not sip trunk.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...