I recently delete my startup configuration, so now I have no configuration on my UC500. When I try to access the GUI and CCA using 10.1.1.1, It doesn't connect on either. The way im doing this is with my PC connected to a LAN port on the UC 500. Do I need to set up an IP address on the UC to be able to access the GUI? Thanks
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...