I have a user that would like to program in their cell phone to their speed dial so they can check their voicemail. Is there a way they can insert a 3 second pause after the cell # on the speed dial so that they can follow their phone number by their password so it will go right in to their messages?
There is a way to configure this using CLI (not supported in CCA). Configure the speed-dial with phone number. Create an outgoing pots dial-peer with specific match (destination-pattern = cell phone #). Then use the prefix command in the following format:
where, "1" is the longdistance code, "4085551111" is the cell phone number, "," will insert the pauses that you are looking for and "123" is the password.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...