Proxy Server (primary) sipconnect.mia0.cbeyond.net
Registrar Server sip-proxy.mia0.cbeyond.net
Outbound Proxy Server sip-proxy.mia0.cbeyond.net
SIP Domain name cbeyond.net
DNS Server address 18.104.22.168
For the life of this thing and 6 hours with Cbeyond and Cisco, Cbeyond escalated this to Tier 2 support, Cisco says its the carriers fault, and it will NOT register the SIP. Cat5e connection goes from the Cisco IAD directly to the WAN port of the UC540. The NAT is defaulted, The WAN portion of the setup is correct, all the computers can get to the internet no problem....I do not know what else to do...I have until MONDAY to figure this out and I am running out of time....PLEASE HELP....below is what it spits out when I refresh the trunk status....
----------- show sip-ua register status -----------
Line peer expires(sec) registered P-Associ-URI ================================ ========== ============ ========== ============ 9545338980 20013 39 no
SIP User Agent Status SIP User Agent for UDP : ENABLED SIP User Agent for TCP : ENABLED
SIP User Agent for TLS over TCP : ENABLED SIP User Agent bind status(signaling): DISABLED SIP User Agent bind status(media): DISABLED SIP early-media for 180 responses with SDP: ENABLED SIP max-forwards : 70 SIP DNS SRV version: 2 (rfc 2782) NAT Settings for the SIP-UA Role in SDP: NONE Check media source packets: DISABLED Maximum duration for a telephone-event in NOTIFYs: 2000 ms SIP support for ISDN SUSPEND/RESUME: ENABLED Redirection (3xx) message handling: ENABLED Reason Header will override Response/Request Codes: DISABLED Out-of-dialog Refer: DISABLED Presence support is DISABLED protocol mode is ipv4
SDP application configuration: Version line (v=) required Owner line (o=) required Timespec line (t=) required Media supported: audio video image Network types supported: IN Address types supported: IP4 IP6 Transport types supported: RTP/AVP udptl
Let me start off by saying thank you very much for your help. The SIP does register now, it is just so hard to believe that the carrier couldn't even tell me the settings. I think I just have a routing problem now, the main number rings in fine, 9545338980, but the 855 numbers when you call it say "your call cannot be completed as dialed" I am going in today to see what I can do about that, hopefully its a simple fix. I'm sure in the next few hours I will be posting my next hurdle with this system.
It all FINALLY works!.....I was not told this when Cbeyond installed the circuit but the 855's are routed to local DID's....I built routes for the 855's but since they are translated into local DID's the calls had nowhere to go so I had to build routes for those and it worked...each department has its own 855 and its outbound caller ID for each department is its own local DID...the only thing I have left to do is figure out how to monitor the agents call usage, calls taken, average length of call etc. and how to setup the call accounting....again thank you Bongsu for ALL your help, I am totally frustrated with both Cbeyond and Cisco over this weekend, nothing worked and both sides blamed the other, funny to me that I get more help on these forums than I do actually contacting the TAC or the SIP carrier.....
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...