For some reason, any changes I make to the telephony voice section will not save. I click apply. I click ok. Nothing happens either way. I noticed the telnet box was unchecked under device access. I checked that but it did not make a difference. Nothing is in red that needs to be fixed. If there are red boxs, I fix them, the tabs turn green and I still can not save.
I have tried 2 different computers and multiple UC500s all with the same result.
If you press F2 then F3 when in the CCA 2.0 GUI then make a change for voice (anything) and then click apply, a small console window will open and spit out some data. See if there are any hints in there...
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...