I have seen this about 5 times or so now. Every once in a while I open CCA 3.01 my system and it crashes my phone system. I have software pack 8.1.0 and the IOS image is UC500-advipservicesk9-mz.151-2.T2 adn CME version 8.0.3. Locale is US English.
All I do is open CCA, enter username and password for the Uc540 phone system and bang... all the phones stop getting power, all the data on the network stops. The UC500 is nonresponsive. I can not PING it nor communicate with it. All the power is on the BOX and it has activity lights etc.
has anyone else experienced this? I have to pull the power on the system and then it comes back up and I can open CCA and get into the Uc540 just fine. Then a few weeks or so will go by and I will open CCA a half a dozen times with no issues... then one random day *bang*..again it goes down. Today it happened... hence this post..
The first time I upgraded to 3.0.1 this happened to me. It never happened before that.. since I was upgrading CCA to 3.0.1 I was going in often because I wanted to see the new features and message around with some T.37 Fax things... and it happened 3 times within the week... I must have went in 10 or so times... anyway... any feedback would be appreciated.
What would be great is if you could use a console cable into the system and then see what come sup on the terminal monitor messages when this happens.
I only suggest term mon because I would not even know where to begin with what debug to run, but if something comes up on the terminal monitor then it may indicate where to start.
Is this a possible option?
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...