Re: CCA wants to delete Firewalls setup via the CLI?
I have found that when I adjusted my ACLs for Multisite (via CLI) I saw the same behavior. I immediately raised it as a request to be implemented in a subsequent release. I think I may have also noticed this when I built a remote teleworker, not sure...have to check.
If you do click on that 'delete unrecognized FW', it will restore everything back to its initial configuration (i.e. without your CLI), in which case you have have to enter it back in again.
Even if you follow the OOB configuration guide, the CCA will not interpret the changes for ACLs applied to FE0/0, just FYI
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...