Change Number of Rings on the Night Service Pick Up
I do not have CCA anymore or a system to pull it up on and get a screen shot for you, but in the Night Service Section of CCA you can set the parameters up for this, and you can have which every phone is set on NS mode to call-forward imediatly to a destination, which in most cases is the VM anyway, but it is possible to do what you want to do
Oh and note that sometimes the phone on the callers end will ring twice before it even rings on the UC, this is especially seen with FXO/Analogue trunks.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...