Anyone know how to change the fast busy tone when calling wrong number?
I do not know if this is possible on the UC, as far as i am aware this is controlled by the carrier, it is their switching equipment that usually dictates this.
When starting to call a number and you have to look for the rest of the number, th display on the phone turn back to default, is there a posibility to change that time?
I believe this is under the telephony-service section, not sure where to find this in CCA but it is to do wit the digit input time out, by default this is set to 5 seconds, on the odd ocassions i get asked to push this out to 10 seconds when you have real fussy customers :)
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...