Need to change the name on a phone in a UC500 system, I was told I had to delete the phone and startover. I am using the CCA. When I did this with Support it the voicemail still had the old name attached and it was not esay to do. Does anyone now a better way?
The only proper way to do it is to delete it, once you delete the user it should also delete the Voice Mail account as well, but at times CCA can miss this or does not do it cleanly (Don't ask, it just happens and quite a fair bit, just be mindful of this ).
HINT: Before deleting the user, go into edit mode on the user and copy the MAC Address, it will remain in the clipboard, but makes life much easier for you.
The other way would be to actually change the users details, but then there is a manual process to log into the voice mail and remove the personal recordings, it works out to be longer rather then just delete and start again
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...