We have been experiencing a problem for a while now, but recently it has started to affect our largest customers who are raising questions.Basically we have a call flow that makes the phone generate a 500 Internal Error SIP message which drops the call.The Scenario is as follows:We have a find me follow me feature and if we set it up to ring the handset for 1 ring and then ring the hsandset again for 2 rings, when the second INVITE comes into the phones, it intermittently ( 30%) of the time throws a 500 Internal Error message. As most customer have a variant for this find me follow me feature it is affecting a lot of people.We need to raise this as a fault so that it can get looked into.I have attached packet traces, but I need a list of other traces that you need in order to investigate the problem
Guess the issue here is that the phone is getting the second invite (with the same call id) within an interval lower than 0.1s the first transaction was closed, so either you change the call id in the second Invite message or you guys increase a little bit that interval at least to 0.5s. The preferred way actually would be to try to change the call id of that second invite.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...