I am trying to setup a UC540W-BRI-K9 with an "Anlagenanschluss" BRI in Germany. This Anlagenanschluss has a 100-number-block of public numbers assigned to it by the provider (1234.00 - 1234.99). When I enter this range in CCA, it says there were to many numbers. CCA accepts only 20 numbers.
Any idea how to properly setup this type of ISDN connection (Provider is QSC) ?
For outbound Calling number presentation, that is the absolute maximum if you use CCA. If you need to go beyond 15 individual DID's represented in the calling number when making outbound calls, then CLI is needed.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...