The voice gateway has 2 ports 0/1 and 0/2. When i try to add those voice ports into the uc5xx it's gives a messages that the command isnt right. The uc5xx already has 4 fxo ports 0/0/0, 0/0/1 etc. How does the uc5xx recognizes the 2 voice gateway ports?
Thx but i still don't know how the uc560 recognizes the VG202.
I only see VG202 configuration but not the configuration for in the uc5xx.
I'm able to configure a whole uc5xx and did this a couple of times but this is a strange thing for me. In a CUCM it's very easy to connects a voice gateway and there is also a little configuration necessary in the CUCM to recognize the voice gateway.
Is there someone who has a configuration example that works for the vg202 and uc5xx?
I don't see the analog ports in CCA. It just makes no sense for me what i must do on the uc5xx so it will recognize the vg202. There must be some configuration on it so the uc5xx knows that there is a vg202 connected to it?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...