I have three Cisco WIP310 IP phones that I wish to use on our corporate network that supports SIP. I have successfully attached one of the phones to the wireless network and configured SIP and the phone works great.
However the other two phones have a differnet issue each:
One of the phones is connected to the network/wireless access points and has a static IP assigned. I can ping the IP address from windows and can confirm the IP address is only used on this one device. I can't however open the web gui using the IP address.
The other phone although I know I'm entering the wireless key correctly using the correct encryptipn type will not connect to the network. I have assigned an IP address that I can also confirm is not used by another device.
Both of these phones are running the same software and hardware versions as the working phone - 5.0.12(12231538) & R03.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...