Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

Config a Snombox PA1 on UC560


For a customer, I need to configure a Snombox PA1 on a UC560.

The PA1 is in fact a SIP-device which allows to speak on a PA-system through your phone (you just call the extension of the PA1)

Now, officially, 3rd party SIP-devices are not supported on a UC560.

With a little help on the web and this forum, I have been able to configure the UC560 via CLI and the PA1 has registered with the UC.So far, so good...

But: when I try to call the extension of the PA1, nothing happens. It seems like the UC doesn't recognize the extension 777 (as it does not appear in the CCA)


voice register global

mode cme

source-address port 5060

max-dn 20

max-pool 10

authenticate register

date-format D/M/Y

file text

create profile sync 0615060624011404


voice register dn  1

number 777

allow watch

name PA

label 777


voice register pool  1

id mac 0004.1333.0595

number 1 dn 1

dtmf-relay sip-notify

username 777 password 12345

codec g711ulaw

I've even tried to create a dial-peer like below, but that doesn't help

dial-peer voice 5010 voip

description **** PA ****

destination-pattern 777

session protocol sipv2

session target ipv4:

session transport tcp

dtmf-relay rtp-nte

codec g711ulaw

no vad

Anyone any insight?


Everyone's tags (3)
Hall of Fame Super Gold

Re: Config a Snombox PA1 on UC560

Most likely, the device is not registering. There are various commands used to troubleshoot, if you search in "ip telephony", the matter is often discussed.

Community Member

Config a Snombox PA1 on UC560


I have the same problem, did you solve the problem?


CreatePlease to create content