Have been trying to configure five ATA-186 with a UC520 without success. The ATA boxes where pretty old and was running config 1.45 and 2.11 so first of all I upgraded them all to the latest firmware. I've given them static IP:s and can access the webconfig but I don't know how to config them from there, they won't show up in CCA unless I manually add them, and the analog phones attached can't call out or call in.
I figured I have to do some config on the ATAs itself? Last time I used ATA boxes things pretty much worked themself out when they showed up in CCA.
I was able to get three of them running with a little help from this document on ATA and CCME. "Note: SID0 and SID1 need to be a . for CCME registration." This was what did the trick!
The other two are not recieving dhcp ip and the green led stays on and does'nt flicker like the others. I've upgraded them to the latest release and done factory reset a couple of times but still no ip. Setting IP manually with IVR does'nt help either. They are the older versions still labeled Komodo if it helps.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...