Hoping someone can assist me with this. I have a uc540 with all fxo lines. On incoming calls the line rings 3 times (monitored with butt test set) before it starts ringing on the phone. Is there somewhere I can adjust this?
Paolo's suggestion should have resolved it, I don't know why it didn't work for you
Can I ask why you want it to be immediate? The reason why you have that delay is because the line is analogue and some carriers do not pass through immediatly the caller-id information, normally with analogue lines it is within 1-2 rings that this information comes through, you can see this realtime if you do a "debug vpm signal".
But I know for a fact that it does work as I have done it many times before on systems where CID was not in place.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) **
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Thanks David. Actually I dont think this customer has caller id on their lines, however, they are stating that callers say the line is ringing 3 to 4 times when it only rings once in the office before the call is answered
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...