I would like to do a factory reset on an SPA921 (5.1.8 firmware) - however when I go to do it, I am asked for an 'admin' password. I've never set an admin password and anything I try is not accepted. I don't care about any settings on the phone and just want to reset it. How do I do this please?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...