planning to do a UC560 factory restore and reinstall using CCA3.0 on a week day. customer doesn't want the down time. so planned to divert the incoming calls to a mobile no while completing the task. will it work. i know we can't do any testing dialing outside lines. but will it possible. and CCA will accept this kind of solutions. after the factory reset, software upgrade, telephony wizard and complete configuration then change the divert back again.
Standard practice would be to do a backup and restore if you had one. I'm not sure what problem you are having but if you feel it's necessary to reconfigure the UC500, I would use the TSW to save some time.
The configuration file of the uc560 is all messed up, it is a Hybrid of CLI and CCA configuration, also its not functioning properly.so planning to rebuild using CCA3.0(1). to enable more functions (AA, multi site ext, etc)
I will be quite busy this weekend but I will try and keep Skype running where possible.
If you get really stuck make sure you call SMB support straight away, don't get yourself all into knots trying to resolve a problem, a 15 minute phone call will fix it up quicker then pondering over the issue.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...