FXO Outgoing Sequential Hunt Scheme limited to two ports
Software PAck 8.1
I have tried this on two UC540's with the same results
I want to dial out on fxo port 0/2 if 0/0 and 0/1 are being used.
In outgoing dial plan I choose the sequential hunt scheme and vertically order the fxo ports with the 1st choice at the bottom, 2nd choice second from the bottom, 3rd choice 3rd from the bottom
when I dial out, it will choose 1 and then 2 and then go back to 1 again. It never gets to three.
If I reorder and put 0/2 as the second choice it will dial 1 first and 3 second and then go back to 1 again.
The method I used to test is to unplug the lines from the ports and watch the link lights. For example, I unplug 0/0 and 0/1, thinking it will try 0/2 after it checks the other two, but it just keeps trying two lines only.
The customer could benefit by dialing out 0/2 (fax line) when the other two are busy.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...