Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

FXS Port MAC Addresses

I need one of the FXS ports to be an ephone.  That should be accomplished by changing the analog port to a user phone but it is not working.  Where do the MAC addresses come from that are used for the FXS ports where I could manually put it back in?

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Re: FXS Port MAC Addresses

Do you have STCAPP configured for the FXS port? If so, you can issue the command "show stcapp device summary". This will show you the MAC address of each SCCP controlled port.

Hope this helps.

Brandon

2 REPLIES
VIP Purple

Re: FXS Port MAC Addresses

Do you have STCAPP configured for the FXS port? If so, you can issue the command "show stcapp device summary". This will show you the MAC address of each SCCP controlled port.

Hope this helps.

Brandon

Community Member

Re: FXS Port MAC Addresses

Thanks for the help.  Once I added the stcapp service, it added the ephone.

862
Views
0
Helpful
2
Replies
CreatePlease to create content