How to open an outbound port on the UC520 firewall without changing the firewall setting in CCA
I need to allow port 8000 outbound but the interface is not using an access list but the ip inspect sdm_low out. Due to changes made to the config it is not compatible with CCA. How can I open that port or any other port without upsetting the whole system?
This entry opens translates the destination port 80 on the outside interface to 10.1.10.1 and port 80. For this to work, my ACL on the outside interface has already opened port 80. Say you need to use the same destination port on a few different web servers, you could do this.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...