How to program softkeys to display bxfer (blind transfer) without having to toggle right
I am using a hosted IP service with Cisco SPA 509G phones. In the connected state - the first two softkeys displays are blank. The thrid shows "conf" and "xfer" on the forth. To do a blind transfer requires you toggle right to see "bxfer" on the third tab.
I need to reposition the "bxfer" to display on one of the open tabs in the initial display.
In the web interface - on the Phone tab - Programmable softkeys - I tried re-working the "Connected Key List:" as follows but it did not work.
Replaced the default value in Connected Key List of
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...