How to provide line seizure for Alarm system with UC540
The customer will have a UC540 with two analog fxo lines wh
ich will be shared with the alarm system as the alarm does not need dedicated phone lines. However they do need to have something called Line Seizure. Does anybody know what is needed for the uc540 to provide line seizure to the alarm system?
Re: How to provide line seizure for Alarm system with UC540
Line Seizure is something done with the wiring between the Alarm system, PBX, and the telephone line. In order to have line seizure, the phone line would have to go into the Alarm System, and then come out of the Alarm system into the PBX.
This is done with an RJ31x jack. Here is a guide to wiring a RJ31X jack:
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...