call flow 3 CO lines go to extension 200 (which is a not a real phone) that number is CFA to a blast group which contains all three operators, then forwards to another blast group that contains everyone.
The night service schedule works fine, but I need to be able to manually enable, and since 200 isn't on any of the phones, it will not work. What should I do to enable any of the operators to enable / disable night service? Should I be handling the inbound calls differently?
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...