Incoming Call -> Operator CFNA -> AA results in fast busy
I have incoming calls setup on FXO ports to ring the operator. After 15 secs, the extension is setup to go to AA. After 15 seconds it goes to a fast busy. I also tried to have incoming calls go to a blast group for 15 secs then AA but the result is the same. When I setup incoming calls to go directly to the AA, it works no problem.
Re: Incoming Call -> Operator CFNA -> AA results in fast busy
Have you checked that the dial-peers for DIDs and the AA uses the same codecs? I've had a similar problem when calls directly to the AA on the main number is OK but calls to the DIDs voicemail fails with fast busy. The CUE will only accept g711 if I remember correctly. Don't know if this applies when using FXO though since my problem was related to a SIP connected box.
Try to set the CFNA to voicemail and see what happens.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...