I have an iPhone4 and the UC540. We are trying to setup the phoen to receive calls. I can get it to coonect to the UC540, however, even with the same number as my DN that my ephone is configured with I cannot get both phones to ring together. Is this possible?
Are you refering to using CIsco Jabber or are you using single number reach? If Jabber, Currently the UC Series does not support shared lines so the iphone (Jabber) would have to be set up with a different extension number. You can then create a blast group and have both extensions in it and that will make both phones ring..
Yes on the voicemail question, they can't synch... Once we can share a line this should not be a problem As for the blast group, yes, remove the extention from your main phone and make it the pilot number of the blast group and put another DN on your main phone. That way people will still call your "known" number and both phones will ring.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...