Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Login problem after 2.1.4(3) update

Hi:

following UC320w instructions I updated firmware to V2.1.4(3). Te update went throughg just fine but when I tried to relog into the system it kept telling me that user and/or password was not correct.

I reset system to factory defoults and went through the whole configuration from scrath and everything was smooth, i loged out and when trying to log in again same problem the usar and password I introduced during config is no good AGAIN, I tried cisco/cisco also but no luck.

Is there any way i can access without the need to reset it AGAIN to factory??. Is this a known issue wit fw version??, shoul I downgrade fw??

Thanks

2 REPLIES
Community Member

Login problem after 2.1.4(3) update

Hello Alejandro,

I work in the Cisco Small Business Support in Europe.

Can you please confirm that the Cisco Small Business Support was able to solve your issue.

Regards,

Friedrich

Community Member

Re: Login problem after 2.1.4(3) update

Yes it is fixed, thans a lot.

2012/1/17 fscharz

**

Home <> Re: Login

problem after 2.1.4(3) update created by Friedrich Scharz<>in

UC300 Series - View the full discussion<>

355
Views
0
Helpful
2
Replies
CreatePlease to create content