cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1178
Views
0
Helpful
1
Replies

Need default factory config for UC540W-FXO-K9

Hello

I lost my password to get into my UC540 using CCA.

I used password recovery that the ISR uses, and I am now able to console into the device and am able to get into enable/privileged mode.

But when I copy the default factory config from flash to the startup config in nvram, it does not work.

All I get is a config that shows the interfaces on the UC540W; no voice vlan ip, no data vlan ip, no certificate encryption keys, etc.etc.

This is really strange.

Does somebody have a copy of the default factory config or a text file of the factory config, so in worst case, I can manually add it?
I dont want to manually add it, but the following command does not work:

copy flash:UC540W-FXO-K9-factory-8.2.0.cfg nvram:startup-config

After I run the command above, I reload, then do a sho run, and I do not see the factory configuration with the data vlan ip and the voice vlan ip, etc. etc.

I also tried: copy flash:startup-config.bak nvram:startup-config    and that does not leave me with the correct startup config either.

Please help.

1 Reply 1

argh

I fixed it.
You need to copy the factory config to running config FIRST.
Then wr mem

Then 0x2102

Then reload

Sh*t

too many beers

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: