Need help changing the default Ring on Ext 1 via provision file
I provision the phones using the <mac address>.cfg that gets pulled from an http server. Here is the config file:
<flat-profile> <!-- Set admin password, time server, and what version of software to run --> <Upgrade_Rule>http://xxx.xxx.xxx.xxx/spa525g-7-3-5.bin</Upgrade_Rule> <Admin_Passwd>xxxxxxx</Admin_Passwd> <Resync_Periodic>3600</Resync_Periodic> <Primary_NTP_Server>xxx.xxx.xxx.xxx</Primary_NTP_Server> <!-- clean up Resync and trigger settings from initial provisioning --> <GPP_A></GPP_A> <Resync_Trigger_1></Resync_Trigger_1> <Resync_Random_Delay>2</Resync_Random_Delay> <Resync_Periodic>3600</Resync_Periodic> <Forced_Resync_Delay>14400</Forced_Resync_Delay> <!-- Set time zone and Day Light Savings time --> <Time_Zone>GMT-06:00</Time_Zone> <Daylight_Saving_Time_Enable>YES</Daylight_Saving_Time_Enable> <!-- XML Corporate Directory --> <XML_Directory_Service_Name>Corporate Directory</XML_Directory_Service_Name> <XML_Directory_Service_URL>http://xxx.xxx.xxx.xxx/directory/test.xml</XML_Directory_Service_URL> <!-- Set Display Names, PBX and Voice Mail Number --> <Station_Name>St. Louis</Station_Name> <Station_Display_Name>St. Louis</Station_Display_Name> <Text_Logo>St. Louis</Text_Logo> <BMP_Picture_Download_URL>http://xxx.xxx.xxx.xxx/images/executive2.jpg</BMP_Picture_Download_URL> <Background_Picture_Type>Download BMP Picture</Background_Picture_Type> <Voice_Mail_Number>98765</Voice_Mail_Number> <Proxy_1_>xxx.xxx.xxx.xxx</Proxy_1_> <!-- Setup extensions --> <Display_Name_1_>77588</Display_Name_1_> <User_ID_1_>77588</User_ID_1_> <Password_1_>7758801</Password_1_> <Default_Ring_1_>5<Default_Ring_1_> </flat-profile>
This does not seem to work. Everytime I reboot the phone the Default Ring for Extension 1 stays the same.
Re: Need help changing the default Ring on Ext 1 via provision f
I saw that also and changed it but it did not fix the situation. After much tinkering I was never able to change the Default Ring from 1 using the XML provisioning file. I did however change it using the file. So instead of focusing on changing the Extensions Default Ring I decided to swap the Rings around. Under the tab, Phone under Admin Advance you have a section where you assign each ring tone a number. I just swapped the positions of the ring tone. Here is the section of the XML Provision file that I used:
Normally Classic is assigned Ring 1 and Office is assigned Ring 10. I just swapped them around. I can only confirm that this works on the SPA942.
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...