Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

New PRI T1 setup, protocol questions.

Hello-

I am setting up a customer with a UC560, and have never configured one for a PRI interface using a T1 WIC. The phone company has asked some questions that I don't know the answer to, and I have been unable to find clear answers after extensive searching. Here are their questions:

1) what protocol do you need to see NI 1, NI2, ATT, ? After searching, I am assuming NT2?

2) switch supervision required ? ( EM1 EM2 ) I did not find any information on this, so I do not know how to respond.

3) how many digits do you want to see (99% chose 4) It sounds like 4 digits? But again, I don't know how to respond.

Any help that can be provided is appreciated.

Thanks,

Derek

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: New PRI T1 setup, protocol questions.

Tell them the following:

Switch Type: NI2

Linecode: B8ZS

Framing: ESF

Digits: 4 is fine unless you have alot of DIDs

You may need to verify if you have control over Caller-ID.  This feature is called Calling Party Number.

2 REPLIES

Re: New PRI T1 setup, protocol questions.

Tell them the following:

Switch Type: NI2

Linecode: B8ZS

Framing: ESF

Digits: 4 is fine unless you have alot of DIDs

You may need to verify if you have control over Caller-ID.  This feature is called Calling Party Number.

Community Member

Re: New PRI T1 setup, protocol questions.

Thanks Nathan. I sent them this information. I appreciate the help!


Derek

1829
Views
0
Helpful
2
Replies
CreatePlease to create content