Presently the outbound CLI for SIP trunking is the "Pilot Number" only and does not allow DDI's to make calls via the SIP trunk, you allow inbound DDI mappings but a number of our customers want the ability to present their individual DDI CLI's, Is this part of the roadmap, and if so when do you think it is due ?
Please Alberto - please can you push this one a little ? The cli per seat issue came up again yesterday with another customer.
As far we we are converned - VoIP.co.uk (Service provider) - we just need to see the SIP From header be different per extension, it could be the extension number or name. We don't need anything more than this as we can re-write everything from our side
Just wanting to see if any updates around outbound CLI presenation for DDI's , Cisco is launching this product in New Zealand this week and the for many customers this is the one big drawback at present, so just want to see if this still on the roadmap and when it is likely to be added.
Both Australian and NZ are going through winter right now it will help with time lines if you can confirm this.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
Configure Multicast Paging on the Cisco IP Phone 7800 Series or 8800 Series Multiplatform Phone
The Cisco IP Phone 7800 and 8800 Series Multiplatform Phones provide voice communication over an Internet Protocol (IP) network...
Add Call Park on a Cisco 7800 or 8800 Series Multiplatform Phone Key Expansion Module
Call park allows the user of the phone to put an incoming call on hold so that the call can be retrieved on another phone. A call is park...